Home > How To > Hard Disk Not Detected In Bios How To Recover Data

Hard Disk Not Detected In Bios How To Recover Data


I formatted it and then it worked. If the Hard Drive is detected, one of the SATA ports on the motherboard is bad. I can see it on my old computer when connected internal via IDE cable. It differs by system, but you usually access by depressing , , , or but in a very few systems, it is The correct one does

And,Then repeat, only reconnect the hard drive and listen for it to spin up.Switch power cables with a device like a CDROM or DVDROM drive, so that you are using a To know more about Dell's products, services and drivers & downloads, please go to Please do write back to us. Bryon15, Mar 24, 2013 Top #5 Member Ryupower Brood Joined: Oct 8, 2007 Messages: 2,779 Country: are you POWERING the drive in so way also test the drive do not use Hello Windows 7 Forum members, For some reason my HP Laptop (Win 7 Home Premium) can't see/recognize my usb external hard drive (seagate).

Hard Disk Not Detected In Bios How To Recover Data

It should see it then... Do NOT use the diagram on one drive to set the jumpers on another. I find it annoying that I have to click on player then internal storage, when it could go directly to internal storage right away. 2.

Flag Permalink This was helpful (0) Collapse - (NT) Good to hear and Thanks for the feedback. Hope this helps. Does it matter that it has XP loaded on it already? Discussion in 'Sony PlayStation 1 & 2' started by Bryon15, Mar 24, 2013.

If that works then replace one of the CD-DVDs with an SATA version...they're only $20-$30 on Newegg. Detecting Ide Drives Error Solution Join the community here. Ask ! Go to control panel.

Ask a Question See Latest Posts TechSpot Forums are dedicated to computer enthusiasts and power users. Do reply with results. Helpful +1 Report Miggin 1Posts Saturday November 9, 2013Registration date November 9, 2013 Last seen Nov 9, 2013 at 03:07 AM Not sure if this is relevant to your motherboard on Reply With Quote 11-01-07,05:41 PM #16 aja View Profile View Forum Posts Member Join Date May 2005 Location SOUTH AFRICA, and yes, we do have electricity, and no, lions dont walk

Detecting Ide Drives Error Solution

Good luck! IF you connect a second HDD on a data ribbon, it MUST have its jumper set to Slave, and into it you plug the Gray middle connector. Hard Disk Not Detected In Bios How To Recover Data I will await your response after the computer is back from repair. Bios Cannot Detect Hard Drive Try another IDE cable and/or another power connection.

I have two hard drives: master( where the OS is installed) and slave. If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). Melde dich bei YouTube an, damit dein Feedback gezählt wird. by Coryphaeus / May 18, 2009 12:31 PM PDT In reply to: Went there You set the jumper for CS? How To Update Bios

  • Sadly, I can't do much there/here unless Win 7 can see/recognize the drive under "My Computer". <> HD is 40GB IDE Seagate (enclosure is PowerSpec 3.5 IDE to USB 2.0) <>
  • When I start/restart my computer and connected the usb cable into laptop, it shows the icon on bottom taskbar (safely remove hardware and when clicked on the usb icon, I see
  • Ii have tried restarting and that does not help.
  • Unless your IDE channels are hot swappable (not likely), then it wouldn't work...
  • Installation & Setup Laptop will not recognize USB Hard DriveI have a Dell D430.
  • Report shree- Sep 3, 2013 at 11:46 AM Good one...........
  • And could it be the motherboard? 'Cause it detects SATA 2 just fine, being the DvD player.
  • by the way, @OP: please do not do what I did!

Jul 31, 2010 #3 mailpup TS Special Forces Posts: 7,009 +375 The jumpers are in masterClick to expand... and they are not always obvious changes by the way they are worded... Bryon15, Mar 25, 2013 Top #13 Member Ryupower Brood Joined: Oct 8, 2007 Messages: 2,779 Country: forget about the USB thing INSTALL THE Drive INSIDE THE PC as a extra drive navigate here A PATA data cable has 3 connectors on it.

I hope this helps others with the same problem. They work with no problem. Do I need to format it first?

HDD The leading standard in enterprise capacity and performance SSD Flash-based storage for instant access to data Systems Building the highest performing and scalable data storage infrastructure possible ⎙Print ✉Mail Share

Connect the Hard Drive to other SATA ports on the motherboard. It finally detected the drive. If the Hard Drive is detected, the problem is with the SATA cable and has to be replaced. And no it should not get so hot you cant touch it max temp should be around 30 degrees Celsius cobleman, Mar 24, 2013 Top #12 OP Member Bryon15 GBAtemp

Aug 20, 2010 #14 (You must log in or sign up to reply here.) Show Ignored Content Similar Topics BIOS not detecting devices Mar 31, 2009 Computer frezzes at "detecting IDE Du kannst diese Einstellung unten ändern. I suppose i could play around with it, there are several options. his comment is here OP Member Bryon15 GBAtemp Maniac Joined: Aug 9, 2010 Messages: 1,091 Location: united states Country: cobleman said: ↑ WinHIIP will not detect a USB connection you will need to connect the

Anmelden Teilen Mehr Melden Möchtest du dieses Video melden? We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks. i boot off my sata btw. Aug 2, 2010 #11 raybay TS Evangelist Posts: 7,241 +9 Nearly all of such issues are caused by setup errors in the BIOS...

A CCM membership gives you access to additional options. The drive is at the end of the cable and jumpered for master. UDMA cables have color coded connections which require proper orientation when connecting. Why? 2 things.

All Rights Reserved. I have done it a few times and it did work for me, every time. well.....i have a dell laptop vostro 1450.......and one more thing I forgot to tell you....once I booted to windows dvd and opened cmd....then opened regedit from cmd.....and when I clicked FILE->IMPORT I booted up into my normal windows( this is where I am as i type).

My System Specs System Manufacturer/Model Number HP Pavilion Phoenix H9-1060sc OS Windows 8 Pro 64-Bit CPU Intel Core i7 (2nd Gen) 2600 / 3.4 GHz Motherboard IPISB-CH2 (Chicago) Memory 16 GB It takes less than a minute and is completely free! Jun 25, 2009 #1 gguerra TS Maniac Posts: 317 I would check the BIOS and not even bother with the OS.